Hi,
I'm ready to install a new HxC in my SP1200.
In videos found online I see where to add jumpers, but on my Hxc model the pins where jumpers had to be added are replaced by a switch.
(see attached picture)
So what are the correct settings for SP1200 on that little switch?
By default ID0A is up, while ID1A, ID2A, ID3A, ID0B, ID1B, ID2B and ID3B are down.
Sorry if this subject was covered somewhere else on the forum.
no more pins / jumpers on the new HxC
no more pins / jumpers on the new HxC
- Attachments
-
- IMG_1341.jpg (148.7 KiB) Viewed 5742 times
Re: no more pins / jumpers on the new HxC
ID0A up is fine for the SP1200.
Re: no more pins / jumpers on the new HxC
Thank You Jeff!