![Smile :)](./images/smilies/icon_smile.gif)
I got a Gotek SFRC922D (LED 3 digits display) and want to use it in an AKAI S2800
I connect my USB>RS232 Adapter Pin 2=RX to pin3 on the gotek and 3=TX>Pin2 Gotek , GRD>Pin6, 5V>Pin7 and bridged J3>3,3V power on, everything looks fine
NO USB STick conected yet
Serial Port COM8, Link is UP (in Serial Bridge SW)
but only bottom Line TX counting up slowly (now14)
I tried 3x an waited
Then it says "No response from device"
I reset Gotek by short P1RST and P6 (no reaction on Gotek SFRC922D)
Restart Serial Bridge SW
Same again...
Very Greatful for support!
regards Duesentrieb