Hi we are Jeff,
Is the LCD screen supposed to say AUTOBOOT.HFE at boot up?
Regards
Marc
Pics:
Atari ST 1040FM HXC Not Working?
Re: Atari ST 1040FM HXC Not Working?
- Attachments
-
- hxc_2.jpg (75.2 KiB) Viewed 8339 times
-
- hxc_1.jpg (115.06 KiB) Viewed 8339 times
Re: Atari ST 1040FM HXC Not Working?
The files on the SD card, are from the HXC2001 Headquarters,
on the card are the Atari ST HXCDFE.CFG, copied first, then the
AUTOBOOT.HFE files, specifically from the Atari ST folder, in the HXC
Floppy Emulator Manager folder.
Thankyou
Marc
on the card are the Atari ST HXCDFE.CFG, copied first, then the
AUTOBOOT.HFE files, specifically from the Atari ST folder, in the HXC
Floppy Emulator Manager folder.
Thankyou
Marc
Re: Atari ST 1040FM HXC Not Working?
Floppy extension plugged in the opposite way, red marker to the left,
tried plugging in extension both ways at either ends, still getting the same issue.
Is the floppy LED access light supposed to be on all the time?
Regards
Marc
tried plugging in extension both ways at either ends, still getting the same issue.
Is the floppy LED access light supposed to be on all the time?
Regards
Marc
- Attachments
-
- IMG_20180314_084651[1].jpg (117.33 KiB) Viewed 8335 times
Re: Atari ST 1040FM HXC Not Working?
the situation is the same : "RA" and "S:1" and the select led permanently on.
You need to invert only one end of the floppy ribbon.
Re: Atari ST 1040FM HXC Not Working?
It is only inverted on one end of the floppy extension?
Might be worth attaching the Rev C to the computers original ribbon, exclude the floppy extension, work back, sure that will show if theres a fault with the Rev C board?
Regards
Marc
Might be worth attaching the Rev C to the computers original ribbon, exclude the floppy extension, work back, sure that will show if theres a fault with the Rev C board?
Regards
Marc
Re: Atari ST 1040FM HXC Not Working?
yes this can be a good test to do.